Table of Contents
Advertisement
Supported RAID Controllers and Required Cables
Table 7:
Controller
Style
ENCS-MRAID
PCIe
Controller
Note
This
controller
cannot
be
ordered
with
2
FBWC.
1 SCPM = SuperCap power module (RAID backup unit).
2 FBWC: modular flash-based write cache.
3 When using SED drive.
RAID Cabling
Cisco ENCS-MRAID card does not require additional cable to connect hard drives and RAID card. The flex
cable connected to the mainboard can be used to connect to RAID card.
RAID Card LED Indicator
When RAID card is installed, the LED indicator in the front bezel should turn in solid green.
•
RAID Card Firmware Compatibility, on page 38
•
ENCS-MRAID Controller Considerations, on page 38
•
Support Matrix For ENCS-MRAID Controller, on page 38
•
Drive Types and Sizes Supported, on page 39
•
ENCS-MRAID Drive and Predictive Failure Behavior, on page 39
•
Setting the Preferred Boot Device Order for ENCS-MRAID, on page 39
Maximum
RAID Levels
Front-Facing
Drives
Controlled
SFF drives: 2
0, 1, JBOD
internal drives
Cisco 5400 Enterprise Network Compute System Hardware Installation Guide
5
C H A P T E R
1
Required
SCPM
Cables
Not required
Not Available
Full Disk
Encryption
3
Yes
37
Advertisement
Table of Contents
