Installing The Ips 4345 In A Rack - Cisco IPS 7.1 Installation Manual

Rack Mount Installation

Installing the IPS 4345 in a Rack

The IPS 4345 ships with the rack mount brackets installed on the front of the chassis. Use these brackets
to mount the chassis to the front of the rack. If you want to mount the chassis on the back of the rack,
you can move the brackets from the front to the back of the chassis.
To rack-mount the chassis, perform the following steps:
If you are keeping the front rack mount brackets, go to Step 4. If you want to move the front rack mount
Step 1
brackets to the back of the chassis, go to Step 2.
Step 2 Remove the rack-mount brackets from the chassis as shown in
Figure 6-8
Step 3 Install the brackets on the back of the chassis by attaching the brackets to the holes in the chassis as
shown in
Figure 6-9
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
6-10
Removing the Brackets from the Front of the Chassis
Figure 6-9. After the brackets are secured to the chassis, you can rack-mount it.
Installing the Brackets on the Back of the Chassis
Chapter 6 Installing the IPS 4345 and IPS 4360
Figure 6-8.
OL-24002-01