Supported Standards, Mibs, And Rfcs - Cisco Octal-Port DMT ATU-C Line Card Information Manual

Octal-Port DMT ATU-C Line Card

Supported Standards, MIBs, and RFCs

Standards
•
•
•
•
•
•
Standard MIBS
To obtain lists of supported MIBs by platform and Cisco IOS release and to download MIB modules, go
to the Cisco MIB web site on Cisco Connection Online (CCO) at
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml.
•
•
•
Cisco-Derived MIBS
•
•
To obtain lists of supported MIBs by platform and Cisco IOS release and to download MIB modules, go
to the Cisco MIB web site on Cisco Connection Online (CCO) at
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml.
ANSI T1.413-Issue 2, Category 1 only
ANSI T1.413-Issue 2, Annex F (Reduced NEXT)
Universal Test & Operations PHY for ATM, Level 2; A standard for transport of ATM cells over a
16-bit parallel data bus. See ATM Forum document af-phy-0039.000.
ITU G.992.1, Annex A (G.dmt)
ITU G.992.2. (G.lite)
ITU G.994.1. (G.hs)
IETF RFC 1695, Definitions of Managed Objects for ATM Management Version 8.0 using SMIv2
IETF RFC 2662, Definitions of Managed Objects for the ADSL Line (obsoletes ADSL Forum TR-
006, SNMP-based ADSL Line MIB)
Objects not supported for 8xDMT:
–
From AdslLineConfProfileEntry - adslAtucConfRateChanRatio, adslAtucConfMaxSnrMgn,
adslAtucConfUpshiftSnrMgn, adslAturConfRateChanRatio, adslAturConfMaxSnrMgn,
adslAturConfUpshiftSnrMgn,adslAturConfMinUpshiftTime.
AdslLineAlarmConfProfileEntry
ADSL Forum TR-014, DMT Line Code Specific MIB
Objects not supported for 8xDMT:
–
From AdslLineDmtConfProfileEntry- adslAtucDmtConfFreqBins, adslAturDmtConfFreqBins,
adslAtucDmtConfInterleavePath, adslAtucDmtConfFastPath, adslAturDmtConfInterleavePath,
adslAturDmtConfFastPath.
CISCO-ADSL-LINE-MIB
Objects not supported for DMT8:
–
CISCO-ADSL-DMT-LINE-MIB
– Objects not supported for DMT8:
From the cAdslDmtLineConfProfileGroup cAdslAtucDmtConfBitSwapEnabled,
cAdslAtucDmtConfBitSwapFrom, cAdslAtucDmtConfBitSwapTo. You can set these objects
via SNMP, however, the 8xDMT cards will ignore these objects when provisioning ports
for service.
Supported Standards, MIBs, and RFCs
Cisco IOS Release 12.1(6)DA
5