Cisco IPS 7.1 Installation Manual page 256

Advanced Setup
Note
[1] Modify interface default-vlan.
Option:
Press Enter to return to the top-level interface and virtual sensor configuration menu.
Step 9
[1] Edit Interface Configuration
[2] Edit Virtual Sensor Configuration
[3] Display configuration
Option:
Step 10 Enter
[1] Remove virtual sensor.
[2] Modify "vs0" virtual sensor configuration.
[3] Create new virtual sensor.
Option:
Enter
Step 11
Virtual Sensor: vs0
Anomaly Detection: ad0
Event Action Rules: rules0
Signature Definitions: sig0
No Interfaces to remove.
Unassigned:
Monitored:
[1] PortChannel 0/0
Add Interface:
Step 12 Enter
Note
Press Enter to return to the main virtual sensor menu.
Step 13
Enter
Step 14
Name[]:
Enter a name and description for your virtual sensor.
Step 15
Name[]: newVs
Description[Created via setup by user cisco]: New Sensor
Anomaly Detection Configuration
[1] ad0
[2] Create a new anomaly detection configuration
Option[2]:
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
B-18
You do not need to configure interfaces on the ASA 5500-X IPS SSP. You should ignore the
modify interface default VLAN setting. The separation of traffic across virtual sensors is
configured differently for the ASA 5500-X IPS SSP than for other sensors.
to edit the virtual sensor configuration.
2
to modify the virtual sensor vs0 configuration.
2
to add PortChannel 0/0 to virtual sensor vs0.
1
Multiple virtual sensors are supported. The adaptive security appliance can direct packets to
specific virtual sensors or can send packets to be monitored by a default virtual sensor. The
default virtual sensor is the virtual sensor to which you assign PortChannel 0/0. We recommend
that you assign PortChannel 0/0 to vs0, but you can assign it to another virtual sensor if you want
to.
to create a virtual sensor.
3
Appendix B Initializing the Sensor
OL-24002-01