Cisco IPS 7.1 Installation Manual page 111

Chapter 5 Installing the IPS 4270-20
Step 5 Attach the slide assemblies to the rack.
For round- and square-hole racks:
Line up the studs on the slide assembly with the holes on the inside of the rack and snap in to place.
a.
Adjust the slide assembly lengthwise to fit the rack. The spring latch locks the slide assembly into
b.
position.
c. Repeat for each slide assembly. Make sure the slide assemblies line up with each other in the rack.
Lift the spring latch to release the slide assembly if you need to reposition it.
d.
OL-24002-01
1
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
Installing the Rail System Kit
2
1
3
5-21