Installing And Removing The Power Supply - Cisco IPS 7.1 Installation Manual

Chapter 4 Installing the IPS 4260
For More Information
•
•
•
•
•
•
•

Installing and Removing the Power Supply

The IPS 4260 ships with one power supply, but you can order it with two power supplies so that you have
a redundant power supply.
To install and remove power supplies, follow these steps:
Log in to the CLI.
Step 1
Prepare the IPS 4260 to be powered off. Wait for the power down message before continuing with Step 3.
Step 2
sensor# reset powerdown
Note
Power off the IPS 4260.
Step 3
Step 4 Remove the power cable and other cables from the IPS 4260.
Note
OL-24002-01
For the procedure for attaching power cords and cables to the IPS 4260, see
page 4-16.
For an illustration of the expansion card slots, see
For an illustration of the supported PCI cards, see
For the IDM procedure for resetting the IPS 4260, refer to
procedure for resetting the IPS 4260, refer to
For the procedure for removing the IPS 4260 from a rack, see
For more information on ESD-controlled environments, see
For the procedure for removing the chassis cover, see
page 4-19.
You can also power off the IPS 4260 using the IDM or the IME.
Power supplies are hot-swappable. You can replace a power supply while the IPS 4260 is
running, if you are replacing a redundant power supply.
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
Installing and Removing the Power Supply
Figure 4-6 on page 4-8.
Supported Interface Cards, page
Rebooting the
Rebooting the Sensor.
Rack Mounting, page
Safety Recommendations, page 2-2.
Removing and Replacing the Chassis Cover,
Installing the IPS 4260,
4-3.
Sensor; for the IME
4-10.
4-23