Accessories; Rack Mounting - Cisco IPS 7.1 Installation Manual

Accessories

Table 4-4
Shock
Vibration
Accessories
IMPORTANT SAFETY INSTRUCTIONS
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
The IPS 4260 accessories kit contains the following:
•
•
•
•
•

Rack Mounting

You can rack mount the IPS 4260 in a 2- or 4-post rack. This section describes how to rack mount the
IPS 4260 and contains the following topics:
•
•
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
4-10
IPS 4260 Specifications (continued)
Operating Half-sine 2 G, 11 ms pulse, 100 pulses
Nonoperating 25 G, 170 inches/sec delta V
2.2 Grms, 10 minutes per axis on all three axes
DB25 connector
DB9 connector
Rack mounting kit—screws, washers, and metal bracket
RJ45 console cable
Two 6-ft Ethernet cables
Installing the IPS 4260 in a 4-Post Rack, page 4-11
Installing the IPS 4260 in a 2-Post Rack, page 4-14
Chapter 4 Installing the IPS 4260
OL-24002-01