Image Data Set Command - Toshiba B-SX600 Series Command Manual

1. IMAGE DATA SET COMMAND

Format
Byte/bit 7 6
0
Header
1
2
Command identifier
3
4
Reserved
to
7
8
Image length [line]
9
10
Image width [word]
11
12
X-direction offset [dot]
13
14
Y-direction offset [dot]
15
16
Image mode
17
18
Reserved (Ribbon save information)
to
21
22
to Reserved (Verification information)
25
26
Reserved (Print length at portrait orientation)
27
Function
Sets the image buffer information used for printing and re-organizes the image buffer.
Explanation
• The data in the image buffer is not cleared.
• Set the print length in units of lines, and it must be equal to or less than the image buffer length.
• Set the print width in units of words (16 dots), and it must be equal to or less than the one-sixteenth
(1/16) of the image buffer width.
• Set the X-direction offset in units of dots, and it must be within the range from 0 to 'image buffer width
minus 1'.
When any value other than 0 is set for the X-direction offset, the print position of an image will shift to
the right by the specified dots, as viewed from the printer back. If performing an X-direction offset
caused a part of the image to be positioned outside of the print head width, such part will not be printed.
5 4 3 2 1 0
'/'
'T'
'I'
'I'
00h image.buf
00h
00h
image.length
image.width
image.xoffset
image.yoffset
image.mode
00h image.rsp
00h
00h
00h image.vsp
00h
00h
00h image.total_length
00h
- 2 -
B-SX600 Command Manual
Remarks