Compaq ProLiant DL380 - G2 Server Setup And Installation Manual page 40

3-4 Compaq ProLiant DL380 Generation 2 Server Setup and Installation Guide
3. Press the front unit identification LED switch on the server front
panel . Blue LEDs illuminate in the switches on the server's front and


rear panels.
4. Press the server Power On/Standby button to place the server in standby
mode . When the server activates standby power mode, the system

power LED turns to amber. For more information about LEDs, see
Appendix E, "LED Indicators and Switches."
Figure 3-1. Activating the front unit identification LED switch and setting the
Power On/Standby button to the standby power mode
WARNING: Moving your server Power On/Standby button to the standby
position removes power from most areas of the server. However, portions of the
power supply and some internal circuitry remain active until the AC power cord
is removed.
1
2