Intel P8700 - Core 2 Duo Processor Datasheet page 42

Table 12. Voltage and Current Specifications for the Ultra-Low-Voltage, Single-Core
(5.5 W) SFF Processor
Symbol
I Deep Sleep
CC
I HFM
DSLP
SuperLFM
I I Deeper Sleep
DPRSLP CC
I I Intel Enhanced Deeper Sleep State
DC4 CC
I I Deep Power Down Technology State (C6)
DPWDN CC
V Power Supply Current Slew Rate at Processor
CC
dI
CC/
DT Package Pin
I I for V
CCA CC
CCA
I for V
CC CCP
I
CCP
for V Supply after V
I
CC CCP
NOTES:
1. Each processor is programmed with a maximum valid voltage identification value (VID), which is set at
manufacturing and cannot be altered. Individual maximum VID values are calibrated during manufacturing
such that two processors at the same frequency may have different settings within the VID range. Note
that this differs from the VID employed by the processor during a power management event (Intel Thermal
Monitor 2, Enhanced Intel SpeedStep Technology, or Enhanced Halt State).
2. The voltage specifications are assumed to be measured across V
a 100-MHz bandwidth oscilloscope, 1.5-pF maximum probe capacitance, and 1-MΩ minimum impedance.
The maximum length of ground wire on the probe should be less than 5 mm. Ensure external noise from
the system is not coupled in the scope probe.
3. Specified at 100 °C T
4. Specified at the nominal V
5. Measured at the bulk capacitors on the motherboard.
6. V tolerance shown in
CC,BOOT
7. Based on simulations and averaged over the duration of any change in current. Specified by design/
characterization at nominal V
8. This is a power-up peak current specification that is applicable when V
9. This is a steady-state I
10. Processor I requirements in Intel Dynamic Acceleration Technology mode are lesser than I
CC
11. The maximum delta between Intel Enhanced Deeper Sleep and LFM on the processor will be lesser than or
equal to 300 mV.
42
Parameter
Supply
Supply before V Stable
CC
Stable
CC
.
J
.
CC
Figure 4 and Figure
. Not 100% tested.
CC
current specification that is applicable when both V
CC
Min Typ
— —
— —
— —
— —
— —
— —
— —
and V
CC_SENSE
5.
is high and V
CCP
Electrical Specifications
Max Unit Notes
3.3 A 3, 4, 12
3.0
2.1 A 3, 4
1.9 A 3, 4
1.7 A 3, 4
600 mA/µs 7, 9
130 mA
4.5 A 10
2.5 A 11
pins at socket with
SS_SENSE
is low.
CC_CORE
and V are high.
CCP CC_CORE
in HFM
CC
Datasheet