Dell QLogic Family of Adapters User Manual page 118

iBFT Boot Setup: QLogic QME8242 Mezzanine Card User's Guide
7. Press the <Esc> key to return to the Adapter Settings menu.
8. On the Adapter Settings menu, select Primary Target Settings and then press <Enter>.
9. Under Target Settings, configure the following, as shown in
a. If the Target Param From DHCP was disabled in
and Boot LUN to the appropriate settings for the target setup.
b. (Optional) Specify the CHAP Type as one of the following:
None to disable CHAP
One-Way for a target-authenticating initiator
Mutual to enable both the target and initiator to authenticate each other
c. (Optional) Configure the Target CHAP Name and Target CHAP Secret as needed.
Figure 7. Configuring Target Settings for IPv4 (Dynamic)
10. Press the <Esc> key and save the settings.
11. Reboot the system.
Setting Up iBFT on IPv6
file:///T|/htdocs/NETWORK/QLogic/71922/en/ibft.htm[9/26/2012 4:26:32 PM]
Figure 7:
step 6, set the Target Name, Target IP Address, Target Port,