Removal Procedure - NEC Express5800/140Rc-4 User Manual

3-22 Setting Up Your Server

Removal Procedure

More than one person should remove the server from the rack.
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-3
to 1-8 for details.
1.
After confirming that the server is off-powered, remove the power cords and all interface
cables connected to the server.
2.
Loosen two screws with which the cable arm is fixed to the rear of the server to remove
the cable arm from the server.
3.
Release the security lock to remove the front bezel.
Do not lift the server only by a single person.
Do not pinch your finger with mechanical components.
Note high temperature.
Do not pull out a device from the rack if the rack is unstable.
Do not leave more than one device being pulled out from the rack.
CAUTION
Cable arm
Screws