NEC Express5800/140Rc-4 User Manual page 85

9.
Loosen the three screws with which the slide bracket of the slide rail assemble is fixed.
This step is required to match the length of the slide rail assembly with the depth of the
rack (distance between the front and rear supports). If the three screws are loosened, the
slide bracket may be slid in the front or rear direction.
Screws
10.
Locate the slide rail assembly on the right side of the rack frame at the position defined by
the template.
NOTES:
Check the direction of installing the slide rail assembly.
– Make the bracket face facing the outside of the rack.
– Locate the side with the slide bracket at the rear of the rack.
The front and rear supports of the rack have rectangular holes for
screw fastening. For the NEC rack, round stamps are provided in 1U.
As shown in the figure, locate the slide rail assembly so that a stamp
is positioned at the upper right of the top screw hole of the slide rail
assembly.
Setting Up Your Server 3-13
Stamp of two circles
(placed in 5U)
Stamp (located at the upper
right position of screw hole)
Screw hole