NEC Express5800/140Rc-4 User Manual page 147

Exiting the Utility
To exit the utility, press Esc until a message prompts you to exit (if you changed any setting, you are
prompted to save the changes before you exit).
Configure/View Host Adapter Settings
The Configure/View Host Adapter Settings has the following menu items and parameters. Read
descriptions to select a correct parameter for each menu item.
Configuration
SCSI Bus Interface Definitions
SCSI Controller ID -------------------------------------------
SCSI Controller Parity ---------------------------------------
SCSI Controller Termination -------------------------------
Additional Options
Boot Device Configuration ---------------------------------
SCSI Device Configuration----------------------------------
Advanced Configuration ------------------------------------
<F6> - Reset to Host Adapter Defaults
SCSI Bus Interface Definitions
To set three menu items under "SCSI Bus Interface Definitions", select a menu item with the cursor
keys (↓ or ↑) and press Enter to fix the item. Use the cursor keys (↓ or ↑) for parameter selection.
The following table lists menu items, available parameters, and descriptions.
Menu item
SCSI Controller ID
SCSI Controller Parity
SCSI Controller
Termination
Parameter Description
0 - [7] - 15 Select "7".
[Enabled] Select "Enabled".
Disabled
[Enabled] Enable or disable the SCSI termination.
Disabled Select "Enabled".
Configuring Your Server 4-37
7
Enabled
Automatic
Press<Enter>
Press<Enter>
Press<Enter>
[ ]: Factory-set