Updating The System - NEC Express5800/140Rc-4 User Manual

D-6 Installing Windows Server 2003
7.
If the optional board is installed, select the proper SCSI Adapter and press Enter.
– MegaRAID SCSI 320-2 RAID Controller Driver (When N8103-81F board is installed.)
Continue performing tasks according to the subsequent messages that appear.
For details, refer to "Getting Started".
After installation is completed, be sure to execute the tasks described in "Driver Installation and
Advanced Settings" and "Updating the System" of this manual.
Procedure for License Authentication
Product Key used in the procedure for license authentication should be matched with the COA label
in which the product key contained in Windows Server 2003 is written.
NOTES:
Execute the activation within 30 days. System may be locked after
30 days is passed.
COA label may be attached to your server.

Updating the System

To ensure normal system operation you should update your system using the following procedures.
1.
Logon to the system using the administrator account or other account which is a member
of the Administrators group.
2.
Insert the NEC EXPRESSBUILDER CD-ROM into CD-ROM drive.
Master Control Menu is automatically appeared on the screen.
3.
Click on [Setup] with left mouse button and click on [Update NEC Express5800 system]
section.
4.
Continue your work for system update as the following message.
5.
Click on [Restart Computer] to restart the system.
6.
Remove the NEC EXPRESSBUILDER CD-ROM from the CD-ROM drive immediately
after clicking on [Restart Computer]
IMPORTANT: If you change the configuration of the system (by
adding or removing hardware or Operating system software
components) or repair the system, you must run the system update
again.