Express Setup - NEC Express5800/140Rc-4 User Manual

Express Setup

"Express Setup" is intended for initial setup of the server. Its automatic installation mode guides
the user easily through the process by detailing specific hardware features and providing screen
prompts for software selection and configuration. The program loads the utilities and drivers,
applies RAID settings, partitions the disk, and installs the desired operating system.
If you install Windows Server 2003, Windows 2000 , after a few tasks are completed, all that
remains to be done is to remove the NEC EXPRESSBUILDER CD-ROM and install the Windows
CD-ROM, input a product ID number, and acknowledge the license agreement.
IMPORTANT:
The Express Setup is intended for the initial setup of the server
system and, therefore, the Express Setup clears the contents of the
hard disk.
When the setup is started, do not turn off the server until the setup
is completed, and also make sure not to remove the "Configuration
Diskette" from the floppy disk drive until the message that allow
you to remove it appeared.
Tools
"Tools" is also intended for initial setup of the server. It provides more installation options than
Express Setup and permits the user to quickly create utility support disks, run the Off-line
Maintenance Utility and system diagnostic utility, set up a maintenance partition, and update the
various BIOS programs.
NEC Express5800 NEC EXPRESSBUILDER Ver3. xxxx-x Copyright (C) NEC Corporation 2003
Tools Menu
Save/Restore RAID Configuration Data
Off-line Maintenance Utility
System Diagnostics
Create Support Disk
Setup Maintenance Partition
BIOS/FW/etc. Update
System Management
Help
Return to the Top Menu
Installing and Using Utilities 6-5
RAID Board: Present
Total Drives: 1
Drives in Group: 1
Hot Spares: 1
RAID Level: 7
Write Mode: WRITE_THRU
Maint Part: Present