Configuring Scsi Controller On Baseboard - NEC Express5800/140Rc-4 User Manual

4-36 Configuring Your Server

Configuring SCSI Controller on Baseboard

The following describes configuration for the SCSI controller on the baseboard of the server.
Running the Utility
To run the utility, perform the following procedures:
1.
Power on the Express server.
Press Esc to display the POST execution screen when the following message appears
under the NEC logo.
Press <ESC> to enter boot selection menu
The following message appears while POST is in progress.
IMPORTANT:
controller.
Adaptec SCSI BIOS v4.10
(c) 2002 Adaptec, Inc. All Rights Reserved
2.
Press and hold Ctrl and A.
The SCSISelect utility starts and then, the channel selection menu appears.
3.
Select "AIC-7902 A at slot 00 01:04:00" or "AIC-7902 B at slot 00 01:04:01" in the
channel selection with the cursor keys and press Enter.
The baseboard is provided with two SCSI controller channels. Channel A (01:04:00)
indicates the Ultra 320 SCSI connector (for hard disks); and Channel B (01:04:01)
indicates the Ultra 320 SCSI connector (for 5.25-inch devices and external SCSI devices).
Select the device number in the box and press Enter.
The Options menu appears.
4.
Select "Option" and press Enter.
If you wish to format a disk, verify disk media, or display a list of devices and their SCSI
Ids, select "SCSI Disk Utilities". If you wish to configure the adapter or a device, select
"Configure/View Host Adapter Settings".
The message appears for each additional SCSI
Press <Ctrl> <A> for SCSISelect(TM) Utility!
AIC-7902 A at slot 00 01:04:00
AIC-7902 B at slot 00 01:04:01
Options
Configure/View Host Adapter Settings
SCSI Disk Utilities