Serial Interface - NEC Express5800/140Rc-4 User Manual

Serial Interface

It is possible to move serial port B located at the front of the unit to the rear. Use the serial cable for
the rear face coming with the server for the connection.
The connection procedure is described below:
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Pull out the server from the rack.
3.
Remove the front access cover.
4.
Remove the rear access cover.
5.
Remove the CPU access cover.
6.
Remove the memory board.
7.
Loosen the two screws with which the fan unit is fixed.
8.
Lift the fan unit straight to pull out it from the server.
9.
Remove the serial cable from the connector on the front of the server.
10.
Remove the serial cable from the connector on the baseboard.
IMPORTANT:
Save the removed cable carefully.
Upgrading Your Server 9-71
Serial cable