Updating The System - NEC N8800-103F User Manual

6-8 Troubleshooting
To write data to a dynamic disk, settings described in "Cautions for using the
Windows Recovery Console" in "System Repair" need to be configured in
advance. For details, see "Cautions for using the Windows Recovery Console"
in "System Repair."

Updating the System

IMPORTANT:
NEC Express5800/ft series is a precision instrument. You should ask maintenance personnel to
update the system.
You will need to update the system after you repair the system using Recovery Console.
IMPORTANT:
Make sure to follow the steps below when you have restored the system by using Recovery
Console.
Check the configuration for OS Boot Monitoring function.
If [OS Boot Monitoring] selected in [Monitoring Configuration] of [Server] is not set to
"Disabled", disable it. See "Step 3: Disable OS Boot Monitoring Function" (page 4-9) for
details.
When updating the system, considerations on settings of Power and Screen Saver are required.
If the following settings are enabled when updating the system, the process may stop or the
system update may not be applied properly. Disable the settings by clearing the checkboxes
before updating the system. Reconfigure the following settings as necessary afterwards.
- Settings of Screen Saver
- Power Schemes (Turn off monitor, Turn off hard disks)
- Hibernation (enable Hibernation)
1.
Log on to the system with OS installed as user with Administrative account.
IMPORTANT:
Check that the dual system is configured properly (Confirm that the STATUS LED 2 on
the CPU/IO module illuminates green. See page 4-7 for location of the STATUS LED).