NEC Express5800/340Hb-R N8800-047F User Manual page 136

6-12 Troubleshooting
2) S elect [Intel(R) PROSet II] fro
3) Click [Change/Remove].
At that time, the message on the dialog box will be displayed.
This is a message for confirmation of deletion, so click [OK].
4) Close the [Add or Remove Programs] dialog box.
5) Reboot the system.
IMPORTANT:
next procedure (installation of PROSet II) without rebooting, PROSet II does not
start after reboot. The system may become unstable.
Follow the steps below to install PROSet II again if you performed system update
without rebooting the system.
1. Start a command prompt.
2. Run c:\pnpdrvrs\procomp /proset /s from a command prompt.
3. Reboot the system.
4. Set dual LAN configuration.
m a list of [Currently installed programs:].
Be sure to reboot before updating the system. If you perform the