(2) Make sure that the two BMC Status LEDs of the PCI modules (for Group1/for Group2)
illuminate green.
IMPORTANT:
(3) and on. Otherwise the BMC firmware may become damaged.
(3) Remove the power cord of the AC inlet B (for Group2).
(4) Check that the POWER switch of the PCI module for Group1 is turned on.
(5) Connect the power cord of the AC inlet B (for Group2).
(6) Make sure that two BMC Status LED for PCI modules (for Group 1/for Group 2)
illuminate green.
IMPORTANT:
ft series setup. Otherwise the setup may not be done properly.
Preparation is now completed.
If the BMC Status LED is not illuminating green, do not perform
If the BMC Status LED is not illuminating green, do not start the
Windows Setup 4-13