Step 7: Update Software; Step 8: Connect And Configure Options - NEC Express5800/340Hb-R N8800-047F User Manual

4-46 Windows Setup
St p 7: Update Software e
Follow the instructions below and apply necessary update modules:
<Whe n the NEC Express5800/ft series ft UPDATE CD-ROM has not been used>
Appl y "ft control software Ver3.0 Update module No.001 FD
Proc edure for appl ying "ft control software Ver3.0 Update module No.001 FD"
1. Insert "ft control software Ver3.0 Update module No.001 FD" which was shipp
s rver into the floppy disk drive. e
2. F rom [Start], s
op en Windows Explorer, and double-click "setup.bat" in t
3. Co mmand Prompt displays a message "setup has completed." and the setting is com
4. Press any key on Command Prompt and close the window.
<When th NEC Express5800/ft series ft UPDATE CD-ROM has been used> e
If ou have performed installation using the "NEC Express5800/ft series ft Update CD," apply all y
update modules by referring to "FTOSnn_ReadmeC.doc" in the CD
unnecessary to apply individual update modules here because the atest update module is
automatically applied from the NEC Express5800/ft series ft Update CD OM.
- ft control software (Ver:n.n) update module
Although NEC ESMPRO Agent is automatically installed at the ft seri
is not applied. You need to apply an update module separately from he NEC Express5800/ft
series ft Update CD.

Step 8: Connect and Configure Options

When there are option PCI boards or peripheral devices to connect to the main unit, power off the
main unit. Then, for connecting them, follow the instructions in "PCI board" in the separate volume
of the User's Guide and the manual of the devices.
If LAN or hard disks are added, you need to set dual configurations. For details, see
TIPS:
"Step 5: Set Dual LAN Configuration" (page 4-34) and "Step 8: Connect and Configure
Options" (page 4-46).
Specification of /PAE switch for BOOT.INI file is required when the memory size on the server is
more than 4GB. Windows system d s not use the area over 4GB if /PAE switch is not specified.
R efer to Microsoft Product Support ervices for details of specification method. BOOT.INI file
ex ists on C:\. It will be displayed on the Windows Explorer by selecting [Folder options...] -
[Show hidden files and folders] on the [View] tab.
Below shows the example of the modification.
(Before modification)
[boot loader]
timeout=30
default=multi(0)disk(0)rdisk(0)partition(1)\WINNT
[operating systems]
multi(0)disk(0)rdisk(0)partition(1)\WINNT="Windows Server 2003, Enterprise" /fastdetect
elect [All Programs] – [Accessories] and then click [Windows Explorer] to
oe
S
."
he FD.
-ROM. However, it is
l
-R
es setup, the latest module
t
ed with the
pleted.