Installation Of Server On Rack - NEC Express5800/340Hb-R N8800-047F User Manual

Place that is close to some equipment that causes power noises (e.g., sparks caused by
power-on/off using a relay). If you must install the server close to such equipment, request
your sales agent for separate power cabling or noise filter installation.

Installation of Server on Rack

Install NEC Express5800/ft series on a rack.
IMPORTANT:
Ask your sales agent who has technical knowledge to install or remove the server
from the rack and connect cables to the server. NEC assumes no liability for damage to the server
and components or adverse effect that arises from such works by the user alone.
Observe the following instructions to use the server safely. Failure to follow these
instructions may result in death or serious personal injury. For details, see
Notes for Safe Handling in Chapter 1.
Do not use any rack which does not conform to the relevant standard.
Always use the server in the specified place.
Observe the following instructions to use the server safely. Failure to follow these
instructions may cause a fire, personal injury, or property damage. For details,
see Notes for Safe Handling in Chapter 1.
Do not install the server only by yourself.
Do not install the server on the rack leaving the cover removed.
Do not pinch your finger with mechanical components.
IMPORTANT:
Temperature increase inside the rack and airflow
If you install several components or the ventilation isn't good inside the rack, the internal
temperature may increase due to heat emitted from the components. When the operating
temperatures of NEC Express5800/ft series (10 to 35°C) are exceeded, there is a risk of
malfunction. You must take adequate precautions and measures for airflow inside the rack as well
as in the room so that the internal temperature can be kept within this range during operation.
WARNING
CAUTION
Installing Server 3-5