Troubleshooting; Problems With Nec Expressbuilder - NEC Express5800/340Hb-R N8800-047F User Manual

Troubleshootin
This section describes w
Problems with NE
When the server is not b
Did you set the N
→ If you do not set the NEC EXPRESSBUILDER CD-ROM during POST
server, an error message will appear or the OS will boot.
Is BIOS configuration correct?
→ The boot device order may be specified with the BIOS setup utility of the server. Use the
BIOS setup utility to change the boot device order to boo
drive first.
<Menu to check: [Boot]>
When an error occurs while the NEC EXPRE
appea rs. After this message appears, check the e
t o the error codes listed in t
Message
This machine i s not supported.
NvRA M access error
Hard disk access error
An error message will also be displayed when an error was detected during system diagnosis. Take a
note or print the error message displayed, and contact your sales agent.
g
hat you should do when a trouble occurs in the product.
C EXPRESSBUILDER
ooted from the NEC EXPRESSBUILDER CD-ROM, check
EC EXPRESSBUILDER CD-ROM during POST and restart the server?
he table below.
This NEC EXPRESSBUILDER version is
not designed for this server. Execute the
NEC EXPRESSBUIL
server.
An access to the nonvolatile memory
(N vRAM) is not acceptable.
The hard disk is not connected or it is failed.
Check whether the hard disk is correctly
connected.
SSBUILDER is in progress, the following message
rror and take the appropriate corrective action according
Cause and Remedy
DER on the compliant

Troubleshooting 6-21

the following:
and restart the
t the system from the CD-ROM