NEC Express5800/340Hb-R N8800-047F User Manual page 142

6-18 Troubleshooting
a-4.
a-5.
b) When N8803-031F (Fibre Channel Controller) is connected
b- 1.
b-2.
b -3.
b-4.
b -5.
b-6.
b-7.
b-8.
b-9.
b-10. Click [Finish].
b-11. Check to see that the numb
c) W hen N8104-84 (1000B
c-1.
c-2.
c-3.
c-4.
c-5.
d) When N
d-1.
Run the following command from Command Prompt for updating the driver.
CD-ROM drive:\WINNT\DOTNET\EN> N8804001
The message of update completion will be displayed
"[Update of the driver Completion]
Press any key and terminate."
Start up [Device Manager] by selecting [Start] - [All Programs] - [Administrative
Tools] - [Computer Management].
Check to see [Qlogic QLA23xx PCI Fibre Channel Adapter] appears under [SCSI
and RAID Controllers].
You do not need to perform the steps b-2 and later if the number of [Qlogic
QLA23xx PCI Fibre Channel Adapter]s shown is identical to number of actually
implemented [Qlogic QLA23xx PCI Fibre Channel Adapter]s. If not, go to b-2.
Right-click the [Unknown Device] – [Fibre Channel Controller] on the [Device
Manager], and select [Update Driver].
Select [Install from a list of specific location (Advanced)], and then click [Next].
Select [Don't search. I will choose the driver to install.], and then click [Next].
Select [SCSI and RAID Controllers], and then click [Next].
Do not select a driver on the model list. Click [Have Disk...].
Insert NEC EXPRESSBUILDER into the CD-ROM drive and click [Browse].
Specify the "CD-ROM drive:\WINNT\DRIVERS\QL2300" folder in the "Copy
manufacture's files from:" column, and then click [OK].
Select [Qlogic QLA23xx PCI Fibre Channel Adapter] on the model list and click
[Next].
A warning message tells that you are about to update a driver. Click [Yes] to
continue. The driver will be installed. During the processing, the mouse cursor
may not be moved for 10 to 20 seconds. Please wait.
shown is identical to numbe
Fibre Channel Adapter]s. If no
ASE-SX Adapter)
Execute [Command Prompt].
Run the following command from Command Prompt and move to CD-ROM
drive.
C:\> CD-ROM drive:
Run the following command from Command Prompt and move to the fo
the batch file.
CD-ROM drive:\> cd \WINNT\DOTNET\EN
Run the following command f
CD-ROM drive:\WINNT\DOTNET\EN> N810484.BAT
The message of update completion will be displayed.
"[Update of the driver
Press any key and terminate."
8104-103 (1000 BASE-T Adapter) is connected
E xecute [Command Prompt].
er of [Qlogic QLA23xx PCI Fibre Channel Adapter]s
r of actually implemented [Qlogic QLA23xx PCI
t, repeat the steps 2 to 10.
is connected
rom Command Prom
Completion]
.BAT
.
pt for updating the driver.
lder with