HP 53131A/132A 225 MHz Programming Manual page 57

Keyword/Syntax
[:SENSe] (Cont.)
:EVENt3
:LEVel
[:ABSolute]?
:SLOPe?
:FREQuency
:ARM
[:STARt]
:SLOPe
:SOURce
:STOP
:DIGits
:SLOPe
:SOURce
:TIMer
:EXPected[1|2|3]
:AUTO
Chapter 2 Command Summary
Front Panel to SCPI Command Maps
Table 2-2. HP 53131A/132A SCPI Command Summary (Continued)
Parameter Form
POSitive | NEGative
IMMediate | EXTernal
<numeric_value>
POSitive | NEGative
IMMediate | EXTernal
|
TIMer | DIGits
<numeric_value> [S]
<numeric_value> [HZ]
ON
Programming Guide
Std/ Comments
New
New Subtree. Queries the characteristics of the " trigger
event" for channel 3 input.
New Subtree.
New Query only. Returns the channel 3 input trigger level.
New Query only. Returns the edge of the channel 3 input
that will be considered an event.
Std Subtree. Controls the frequency, frequency ratio, and
period measuring capabilities of the instrument.
New Subtree. Synchronizes the frequency start and stop
arm with events.
New Subtree.
New Sets the slope of the external start arm signal used in
external arming frequency, frequency ratio, and
period measurements. Only applies when
[:SENS]:FREQ:ARM[:STAR]:SOUR EXT is selected.
New Sets the start arm for frequency, frequency ratio, and
period measurements.
New Subtree.
New Sets the resolution in terms of digits used in arming
frequency, frequency ratio, and period
measurements. Only applies when
[:SENS]:FREQ:ARM:STOP:SOUR DIG is selected.
New Sets the slope of the external stop arm signal used in
external arming frequency, frequency ratio, and
period measurements. Only applies when
[:SENS]:FREQ:ARM:STOP:SOUR EXT is selected.
New Sets the stop arm for frequency, frequency ratio, and
period measurements.
New Sets the gate time used in arming frequency,
frequency ratio, and period measurements. Only
applies when [:SENS]:FREQ:ARM:STOP:SOUR TIM
is selected.
New Specifies the approximate frequency of a signal you
expect to measure at channel 1, 2, or 3.
New Configures Counter to perform a pre-measurement
step to automatically determine the approximate
frequency of the measurement signal(s).
2-33