HP 53131A/132A 225 MHz Programming Manual page 63

Keyword/Syntax
[:SENSe] (Cont.)
:TINTerval (Cont.)
:ARM (Cont.)
:ESTOP (Cont.)
[:LAYer[1]]
:SOURce
:TIMer
[:STARt]
:SLOPe
:SOURce
:STOP
:SOURce
:TIMer
Chapter 2 Command Summary
Front Panel to SCPI Command Maps
Table 2-2A. HP 53132A (S/N Prefix 3646 and Above) Time Interval
Arming SCPI Command Summary (Continued)
Parameter Form
IMMediate | TIMer |
INTernal2
<numeric_value>
POSitive | NEGative
IMMediate | EXTernal
IMMediate | TIMer
<numeric_value>
Programming Guide
Std/ Comments
New
New Sets the stop arm delay for Time Interval
measurements.
New Sets the time used to delay the stop arm for
Time Interval measurements. Only applies
when [:SENS]:TINT:ARM:ESTOP:SOUR TIM is
selected.
New
New Sets the slope of the external start arm signal
used in external arming Tme Interval
measurements (including Time Interval, Rise
Time, Fall Time, Dutycycle, and Pulse Width).
Only applies when
[:SENS]:TINT:ARM[:STAR]:SOUR EXT is
selected.
New Sets the start arm for time interval (including
Time Interval, Rise Time, Fall Time, Dutycycle,
and Pulse Width) measurements.
New Subtree.
New Sets the stop arm (i.e., the delay) for Time
Interval measurements.
New Sets the time used to delay the stop arm for
Time Interval measurements. Only applies
when [:SENS]:TINT:ARM:STOP:SOUR TIM is
selected.
2-39