Table of Contents
Advertisement
Chapter 4 Command Reference
:CALCulate2 Subsystem
:CALCulate2:LIMit:UPPer[:DATA] <numeric_value>
[HZ | S | DEG]
Sets or queries the upper limit used for limit testing.
When the result is greater than the upper limit, a fail is reported; when the result is
equal to the upper limit, a fail is not reported.
If math is enabled (:CALC:MATH:STATe ON), the limit value specified should
take into account that the limit testing is on measurements that have been scaled
and offset.
<numeric_value>
-9.9999990000E+12 to -1.0000000000E-13, 0.0000000000, +1.0000000000E-
Range
13 to +9.9999990000E+12.
<numeric_value>
11 digits
Resolution
Query Response
Numeric data transferred as ASCII bytes in <NR3> format with eleven significant
digits.
Comments
Related
Uppr & Lower
Front-Panel
Keys
4-18
*RST: 0.0000000000
This command couples :CALC3:LFIL:UPP to the same value.
Updating the upper limit value causes the limits counts (:CALC2:LIM:FCO,
:CALC2:LIM:PCO) to be cleared.
The front panel menu item is not always able to display all of the significant
digits of this value. When this is the case, the displayed value is different from
the actual value in that the displayed value has been rounded. However, using
the front panel Enter key, while this value is in the 11-digit display, will
update the actual value to the displayed (rounded) value.
Programming Guide
Advertisement
Table of Contents
