HP 53131A/132A 225 MHz Programming Manual page 52

Keyword/Syntax
:DIAGnostic (Cont.)
:CALibration (Cont.)
:ROSCillator
:AUTO
:STATus?
:TINTerval
:FINE
:QUICk
:DISPlay
:ENABle
:MENU
[:STATe]
[:WINDow]
:TEXT
:FEED
:RADix
:FETCh
:FORMat
[:DATA]
:HCOPy
:CONTinuous
Chapter 2 Command Summary
HP 53131A/132A Command Summary
Table 2-2. HP 53131A/132A SCPI Command Summary (Continued)
Parameter Form Std/
New
New
ONCE | OFF New
New
New
[1 | 2 | 3 | 4] New
New
Std
<Boolean> Std
Std
OFF Std
Std
Std
" [:]CALCulate2 " | Std
" [:]CALCulate3 "
COMMa | DPOint New
Std
Std
ASCii | REAL Std
New
<Boolean> New
2-28
Comments
Subtree. ROSCillator is an abbreviation for
Reference OSCillator.
ONCE calibrates the timebase. This command is
usable only if the instrument contains the medium or
high stability oscillator option.
Query only. Returns status of last calibration.
0 = pass; 1 = fail.
Subtree.
Event; no query. Four steps which calibrate out
Ch1, 2 electrical path length differences.
Event; no query. Calibrates out Ch1, 2 electrical path
length differences.
Subsystem. Controls the selection and presentation
of textual information on the display.
Controls whether the whole display is visible.
Subtree.
Sets the Counter to switch from the menu display to
the result display.
Subtree.
Subtree. Allows for the display of textual information.
Sets which data flow is fed into the display. " CALC2"
specifies the raw measurement, scaled/offset
measurement, or Limit Graph display. " CALC3"
specifies the statistics result display.
Sets the character used to separate integral and
fractional portions of a number. (USA numerical
convention is Decimal POint.)
See Measurement Instructions in this table.
Subsystem. Sets a data format for transferring
numeric information.
Sets the data format.
Enables or disables printing results.
Programming Guide