Table of Contents
Advertisement
Chapter 4 Command Reference
Introduction
:STATus:QUEStionable:CONDition?
Queries the status of the Questionable Data Condition Status Register.
Bits are not cleared when read.
Query Response
Comments
The Questionable Data Condition Status Register is cleared at
power-on.
:STATus:QUEStionable:ENABle <non-decimal numeric> | <NRf>
Sets or queries the Questionable Data Event Status Enable Register.
The parameter and query response value, when rounded to an integer value and
expressed in base 2 (binary), represents the bit values of the Questionable Data
Event Status Enable Register. The value of unused bits is zero when queried and
ignored when set.
This register is used to enable a single or inclusive OR group of Questionable
Data Event Status Register events to be summarized in the Status Byte Register
(bit 3).
Range
The range of the <non-decimal numeric> or <NRf> parameter is
0 to 65,535.
Query Response
Numeric data transferred as ASCII bytes in <NR1> format.
Comments
Programming Guide
Numeric data transferred as ASCII bytes in <NR1> format.
Range is 0 to 65,535.
The query response value is an integer formed by the
binary-weighting of the bits. The value of unused bits is zero.
At power-on and :STAT:PRES, the Questionable Data Event Status Enable
Register is cleared (value is 0).
This value is unaffected by *RST and save/recall.
4-111
Advertisement
Table of Contents
