HP 53131A/132A 225 MHz Programming Manual page 56

Keyword/Syntax
:MEMory
:DELete
:MACRo
:FREE
:MACRo?
:NSTates?
:READ
[:SENSe]
:DATA?
:EVENt[1|2]
:HYSTeresis
:RELative
:LEVel
[:ABSolute]
:AUTO
:RELative
:SLOPe
:EVENt2
:FEED
Chapter 2 Command Summary
HP 53131A/132A Command Summary
Table 2-2. HP 53131A/132A SCPI Command Summary (Continued)
Parameter Form
<string>
[" [:]SENSe[1]" ]
<numeric_value> [PCT]
<numeric_value> [V]
<Boolean>
<numeric_value> [PCT]
POSitive | NEGative
" [:]INPut[1] | [:]INPut2 "
______________________________
1
Current firmware revision .
2
Prior firmware revisions 3317, 3335, and 3402.
2-32
Std/ Comments
New
Std Subsystem. Manages instrument
memory.
Std Subtree.
New Event; no query. Deletes the macro with
the name specified by the string
parameter.
Std Subtree.
Std Query only. Returns memory usage and
availability corresponding to macro data.
Std Query only. Returns the number of
available *SAV/*RCL states in the
instrument.
Std See Measurement Instructions in this
table.
Std Subsystem setup commands.
Std Query only. Returns the current
measurement result data of the SENSe
subsystem (no scale or offset applied).
New Subtree. Defines the " trigger event."
New Subtree.
1 Sets the size of the hysteresis window
New
as a percentage of allowable hysteresis.
2 Sets the sensitivity of the input channel
as a percentage of allowable sensitivity.
New Subtree.
New Sets the level at the center of the
hysteresis window.
New Sets the " auto-trigger" enable.
New Sets the percentage of the peak-to-peak
range of the signal at which the
instrument will auto trigger. 0-100%.
New Sets which edge of the input signal will
be considered an event.
New Subtree.
New Sets the common/separate enable.
INPut2 is separate; INPut1 is common.
(Only applies for Time Interval function.)
Programming Guide