Table of Contents
Advertisement
Chapter 4 Command Reference
Group Execute Trigger
(GET)
Group Execute Trigger
(GET)
The full capability of the Group Execute Trigger IEEE 488.1 interface function is
implemented in the Counter. This function permits the Counter to have its
operation initiated over the Bus. The
device-dependent result of this triggering is described in the following paragraph.
In response to the IEEE 488.1 Group Execute Trigger (GET) remote interface
message (while the Counter is addressed to listen),
the Counter performs the action defined by the *DDT command
(see page 4-124).
4-42
Programming Guide
Advertisement
Table of Contents
