Ensuring The Copier/Printer Connection - Fiery EX12 Configuration Manual

3
3-10 Preparing for Fiery Setup
You must configure the Fiery with the correct Windows NT domain name. This is
especially important for Windows printing, also known as SMB printing. For Fiery
systems that include the Fiery Advanced Controller Interface, open the Start
Menu>Settings>Control Panel>Network>Identification tab, and enter the correct
domain name. You must also select "Create a Computer Account in the Domain," and
enter the user name and password of a user who can add workstations to the specified
domain. For configurations that do not include the Fiery Advanced Controller
Interface, you must add the Fiery to the domain from a networked Windows NT 4.0
server, using the Server Manager utility.

Ensuring the copier/printer connection

Complete the following steps before you configure the Fiery and the workstations that
will print to the Fiery. A service technician will have performed some initial
installation.
T F
O PREPARE FOR IERY CONFIGURATION
1. Print a copier/printer test page to verify the copier/printer is functioning normally.
2. Turn off the copier/printer and connect the interface cable from the copier/printer to
the Fiery.
3. To confirm this connection, turn on the copier/printer and the Fiery, and print a Test
Page from the Fiery Control Panel.
To print a Test Page, press the Menu button on the Control Panel to display the
Functions menu. Choose Print Pages, and then choose Test Page.
4. With both the copier/printer and the Fiery turned off, connect the network cable to
the Fiery, as described in
The network should already be installed and operational.
5. Turn on the copier/printer and then the Fiery.
Proceed to Fiery Setup, described in Chapter 4.
Chapter 1.