Configuring A Windows Nt 4.0 Server To Communicate With The Fiery - Fiery EX12 Configuration Manual

2
2-3 Fiery on a TCP/IP network with Windows NT 4.0
Configuring a Windows NT 4.0 server to communicate with
the Fiery
To configure a Windows NT 4.0 server to communicate with the Fiery, follow these
general steps. More detail is provided in subsequent sections in this chapter and in
your Microsoft documentation.
• Load the TCP/IP network protocol on the server and configure it with an
IP address, subnet mask, and gateway.
• Enter the host name of the Fiery in the host database used by your system (see
page 2-4).
• Perform Fiery Setup.
• On the Windows NT 4.0 server, create a printer for each Fiery print connection,
install the appropriate printer drivers, and (optionally) share the printer on the
network (see
• Enter the host name and remote printer name of the Fiery in the printer connection.
For more information, see
• If the Windows NT 4.0 server is also a workstation, install Fiery utilities (see the
User Software Installation
page 2-5).
page 2-18.
Guide).