Ipx/Spx Installations; Tcp/Ip Installations; Setting Up Token Ring On The Fiery; Setting Up Netware Windows Clients - Fiery EX12 Configuration Manual

A
A-3 Token Ring Network Option

IPX/SPX installations

If your network uses IPX/SPX protocols with Token Ring, configure at least one
printer, one Fiery Print Server, and one Fiery Print Queue on the NetWare server as
described in "Configuring a NetWare 4.x server for printing" on page 2-10. You can
configure up to eight bindery servers and one NDS tree connection to the Fiery.
This total is the same whether the Fiery is connected by Token Ring, Ethernet, or
both. For more information, see "Setting up an NDS connection" on page 2-12.

TCP/IP installations

If your network uses TCP/IP protocols with Token Ring, configure at least one
printer and one Fiery queue on a Windows NT server (see "Configuring a
Windows NT 4.0 server to communicate with the Fiery" on page 2-3) or UNIX server
(see "Setting up the Fiery on TCP/IP networks" on page 2-18).

Setting up Token Ring on the Fiery

Token Ring Setup on the Control Panel is similar to Ethernet Setup. From Network
Setup, perform Port Setup, Protocol Setup, and Service Setup. The setups you need are
summarized in the table on page 4-15.
Connect the Token Ring cable before doing Fiery Network Setup, so that the
N :
OTE
Token Ring card can configure itself properly.

Setting up NetWare Windows clients

Client setup is exactly the same as for IPX clients using Ethernet. For details, see
"Setting up NetWare Windows clients for printing" on page 2-13.