Fiery EX12 Configuration Manual page 43

2
2-19 Fiery on a network with UNIX workstations
T F
O SET UP IERY PRINTING ON
1. Specify the appropriate settings in Fiery Server Setup.
To access Fiery Setup, see
2. Specify the appropriate settings in Fiery Network Setup.
Enter a valid IP address, subnet mask, and gateway address for the Fiery.
3. Specify the appropriate settings in Fiery Printer Setup.
Publish the Print queue, Hold queue, and/or Direct queue.
T TCP/IP
O SET UP FOR COMMUNICATION WITH THE
1. A superuser (with root login) must add the Fiery to the network's IP host table or
other system database of network printers.
2. In the file or utility used by your network, specify the remote printer name, the print
server protocol, the queue, and the spool file for the Fiery name you assigned.
3. Make the Fiery available as a printer to other network users.
4. To verify the TCP/IP connection, ping the IP address or the host name. From any
computer on the network, at the command prompt, type:
ping <IP address>
Type the Fiery IP address assigned in Fiery Network Setup.
After the Fiery is set up as a network printer, you can also ping the name you gave to
the Fiery:
ping <hostname>
The server should respond with a message such as
Reply from <IP address> ...
Some systems will respond with a continuous display of output from the IP address.
To stop the output, type
UNIX
SYSTEMS
page 4-8.
F
IERY
You can use the
Control-C.
command at any time.
ping