Chapter 5: Setting Up The Fiery From A Windows Computer; Accessing Setup - Fiery EX12 Configuration Manual

5

5-1 Accessing Setup

Chapter 5:
Setting up
the Fiery from
a Windows
Computer
After you perform initial Setup (Server, Network, and Printer Setup) from the Control
Panel, you can change most Setup options from a Windows computer.
Accessing Setup
In addition to using the Control Panel, you can set up the Fiery two ways: locally
and remotely. Local Setup is for systems with the Fiery Advanced Controller
Interface. Local Setup uses a Windows NT application, Fiery Server Setup.
Remote Setup is performed from a Windows computer using Fiery WebSetup
or Command WorkStation.
In this chapter, illustrations for both Setup interfaces, where applicable, appear
N :
OTE
side by side: local Setup on the left, remote Setup on the right. Descriptions for the
Setup options are listed in the order in which they appear on the local Setup window.
Some Setup options cannot be accessed from remote Setup; use local Setup or the Fiery
Control Panel instead.
Regardless of how you access Setup, you must log in as Administrator, both at the Fiery
and within the Setup application you use. After the Fiery is rebooted, log in at the
Windows NT Logon window with Administrator as the login name and the password,
if required. This login and password are the Windows NT login and password.
To use the Setup applications (Fiery WebSetup or Command WorkStation), you must
enter the Fiery Administrator password. This is set either from the Control Panel,
Fiery WebSetup, or Command WorkStation.
Fiery WebSetup is supported for Windows computers only.
N :
OTE