Section 3: Operation; Boat Setup - Lowrance LMF-400 Installation And Operation Instructions Manual

Multi-function gauge

Hide thumbs Also See for LMF-400:

Installation and operation instructions manual (48 pages)

Table Of Contents

Table of Contents

The displays and settings in this digital gauge are controlled by a five-

button keypad. The buttons are

key gives you access to the basic menu. The

are used to scroll through and highlight menu items. The

key (also referred to as the

through pages, execute commands and select items from menus. The

key is used to close menus and scroll backward through pages.

EXIT

Boat Setup

When the LMF-400 is turned on the first time, the Boat Setup menu

will appear. You will not be able to proceed without completing Boat

Setup. If, however, you have one or more of the following devices —

Suzuki Engine Interface, EP-10 Fuel Flow, EP-15 Fluid Level, EP-45

Pressure Sensor or an EP-50 Storage Device — already configured in

the network with the same engine-tank configuration, you WILL NOT

have to go through boat setup when adding a new gauge to the

network. After adding the gauge to the network, the Boat Setup menu

will be cleared from the screen and the unit will begin normal

operation in 1-2 seconds.

NOTE:

If you add an EP-10 Fuel Flow, EP-15 Fluid Level, EP-45 Water

Pressure or EP-50 Storage Device sensor to the network, you must

go through Boat Setup so the engine-tank configuration will be

consistent among sensors on the network.

To execute Boat Setup:

1. With Boat Setup highlighted on the screen, press

will appear, allowing you to choose the number of engines and fuel

tanks on your vessel. The Boat Setup menu options are: 1 Eng/1 Tank,

1 Eng/2 Tank, 2 Eng/1 Tank, 2 Eng/2 Tanks, 3 Eng/1 Tank or 3 Eng/3

Tanks.