Section 3: Operation; Boat Setup - Lowrance LMF-200 Installation And Operation Instructions Manual

Multi-function gauge

Hide thumbs Also See for LMF-200:

Installation and operation instructions manual (44 pages)

Table Of Contents

Table of Contents

The displays and settings in this digital gauge are controlled by a

three-button keypad. The buttons are

key provides access to menus and helps with data entry and command

execution. The

(highlight) menu items.

Boat Setup

When the LMF-200 is turned on the first time the Boat Setup menu

will appear on the screen. You will not be able to proceed without

completing boat setup. If, however, you have

one or more of the following devices — Suzuki

Engine Interface, EP-10 Fuel Flow, EP-15

Fluid Level, EP-45 Pressure Sensor or an EP-

50 Storage Device — already configured in the

network

with

configuration, you WILL NOT have to go

through boat setup when adding a new gauge

to the network. After adding the gauge to the network, the Boat Setup

menu will be cleared from the screen and the unit will begin normal

operation in 1-2 seconds. If you have more than one gauge on the

network, you will only have to execute Boat Setup for one of the

gauges. When the data is input, it is transmitted over the network and

saved to other units.

NOTE:

If you add an EP-10 Fuel Flow, EP-15 Fluid Level, EP-45 Water

Pressure or EP-50 Storage Device sensor to the network, you must

go through Boat Setup so the engine-tank configuration will be

consistent among sensors on the network.

To execute Boat Setup:

1. With Boat Setup highlighted on the screen, press

Setup menu will appear, allowing you to select an engine-tank

configuration that matches the number of engines and fuel tanks on