Table of Contents
Advertisement
To unconfigure an EP-35 temp sensor:
1. Press
MENU
press
.
ENTER
2. Highlight
B
appear, showing all devices detected on the network.
3. Choose the temp sensor you want to unconfigure and press
Select
U
NCONFIGURE
The following message will appear: Press Menu to UnConfig Device
Name.
4. Press
ENTER
Bus Devices list where the temp now will be listed as UnCfg Temp.
To reconfigure an EP-35 temp sensor:
To reconfigure a sensor, there must be a configuration name available
(Water, Outside or Inside). If all three temp sensors have been
configured, you first will have to unconfigure a temp sensor to make its
name available for reconfiguration. If you try to reconfigure a sensor
when the desired configuration name (Water, Outside and Inside) is in
use, a Name Already Selected message will appear.
If all three temps are configured, which means there is no name
configuration available, follow the first set of instructions. If the desired
configuration name is available, follow the second set of instructions.
The steps below will show you how to switch the configuration of a
water temp to an outside temp.
If all temps configured (Configuration name unavailable):
1. Press
MENU
press
.
ENTER
2. Highlight
B
and press
ENTER
3. Select
U
NCONFIGURE
up: Press Enter to UnConfig Device Name.
4. Press
ENTER
Devices list. The Outside temp is now unconfigured and will be
displayed as UnCfg Temp. Its configuration name (Outside) is now
available, so you will be able to use it to reconfigure the Water temp
sensor.
5. Highlight
configuration menu. Select
direct you to the Temp Selection menu, which will have three options:
Water, Outside and Inside.
, use the
UP
and press
D
US
EVICES
from the temp configuration menu and press
to unconfigure the sensor and be directed back to the
, use the
UP
and press
D
US
EVICES
to open the temp configuration menu.
and press
to unconfigure the sensor and be taken back to the Bus
and press
WTR: T
and
keys to select
DOWN
ENTER
and
keys to select
DOWN
. Select
ENTER
. The following message will pop
ENTER
, which will open the temp
ENTER
R
ECONFIGURE
38
S
. The Bus Devices list will
S
O
: T
UT
and press
ENTER
and
S
YSTEM
ETUP
ENTER
ENTER
and
S
YSTEM
ETUP
(Outside Temp)
. That will
.
.
Hide quick links:
Advertisement
Table of Contents
