Table of Contents
Advertisement
To unconfigure a Suzuki Engine Interface:
The unconfigure command (Unset Engine) allows you to set a Suzuki
Engine
Interface
Unconfiguring an interface also will allow you to change the engine
model selected during configuration.
Unset Engine
1. Press
MENU
press
.
ENTER
2. Highlight
B
3. Select the desired engine interface and press
Interface menu will appear. Select
following message will appear: Press Enter to UnConfig Device Name.
4. Press
ENTER
where the engine interface you unconfigured will be shown as UnCfg
Intrfc.
NOTE:
If, after configuring, unconfiguring or reconfiguring an engine
interface, it is not shown on the Bus Devices list, you will have to
refresh the list. Press
Highlight
with its new configuration setting.
To reconfigure Suzuki Engine Interface (multiple engines
only):
The Change Engine command is used to switch the current
configuration of a Suzuki Engine Interface with the configuration from
a different engine. Change Engine, however, will only appear on your
LMF-400 menu if you are using an engine-tank configuration that
includes multiple engines. If all engine interfaces on your vessel are
configured, you will have to unconfigure an interface to free up its
configuration name (Port, Center, Starboard).
If all three engine interfaces are configured, leaving no name
configuration available, follow the first set of instructions below. If the
desired configuration name is available, follow the second set of
instructions below.
Change Engine (active only with multiple-engine setting)
The steps below show how to switch the configuration name of an
engine interface from the port engine to the starboard engine.
When all engine interfaces are configured (Configuration name
unavailable):
1. Press
MENU
press
.
ENTER
back
, use the
UP
and press
D
US
EVICES
and you will be directed back to the Bus Devices list.,
MENU
and press
B
D
US
EVICES
, use the
UP
to
its
original
and
keys to select
DOWN
to open the Bus Devices list.
ENTER
U
NSET
, select
S
YSTEM
ENTER
and
keys to select
DOWN
49
unconfigured
S
YSTEM
ENTER
and press
E
NGINE
and press
S
ETUP
. The Fuel Flow will be listed
S
YSTEM
status.
and
S
ETUP
. The Engine
. The
ENTER
.
ENTER
and
S
ETUP
Hide quick links:
Advertisement
Table of Contents
