Table of Contents
Advertisement
NOTE:
If you reset values from a fluid level menu, you will only restore
default settings for that particular fluid level sensor. Executing the
Reset Values command will also clear configuration and calibration
settings.
Suzuki Engine Interface Configuration
You can have up to three Suzuki Engine Interface's installed on your
vessel, one for each engine the LMF-400 supports. In a three engine-
tank configuration, the interfaces will be listed as Port Engine, Center
Engine and Stbd Engine. If the engine interface is unconfigured, it will
be listed as Uncfg Eng Int. When accessing an Engine Interface, its
menu will appear with the following options: Change Engine (for two or
more engines only), Fuel Warning, Unset Engine, Reset Values, Reset
Fuel Calibration and Reset Trim Calibration.
NOTE:
If, after configuring, unconfiguring or reconfiguring an engine
interface, it is not shown on the Bus Devices list, you will have to
refresh the list. Press
Highlight
with its new configuration setting.
To configure a Suzuki Engine Interface:
1. Press
MENU
press
.
ENTER
2. Highlight
B
appear.
3. Select
U
C
N
appear: Press Enter to Configure Eng Intrfc.
4. Press
ENTER
DF40, DF50, DF60, DF70, DF90/115, DF140, DF150, DF175,
DF200/225, DF250 and DF300.
5. Select your engine model from the list and press
Engine menu will appear with up to three options (Port, Center and
Starboard), depending on your engine-tank configuration. If you chose
a single engine configuration during Boat Setup, you will be taken back
to the main display.
6. Highlight the engine connected to your engine interface and press
. If, for example, you select the Port, the following message will
ENTER
appear: Press ENTER to change to Port Engine.
7. Press
ENTER
MENU
and press
B
D
US
EVICES
, use the
UP
and press
D
US
EVICES
and press
E
I
FG
NG
NT
. The following list of Suzuki engine models will appear:
. You will be taken back to the main display.
, select
S
YSTEM
ENTER
and
keys to select
DOWN
ENTER
ENTER
48
and press
S
ETUP
. The Fuel Flow will be listed
S
. The Bus Devices list will
. The following message will
ENTER
ENTER
and
S
YSTEM
ETUP
. The Select
.
Hide quick links:
Advertisement
Table of Contents
