Lowrance LMF-400 Installation And Operation Instructions Manual page 47

Change Engine (active only with multiple-engine setting)
The steps below show how to switch the configuration name of a fuel
flow from the port engine to the starboard engine.
If all fuel flows configured (Configuration name unavailable):
1. Press
MENU
press .
ENTER
2. Highlight
B
appear.
3. Select the Port fuel flow and press
press . The following message will appear: Press Enter to
ENTER
UnConfig Device Name.
4. Press
ENTER
the port fuel flow will now be displayed as UnCfg FFlow.
5. Select the Starboard Fuel Flow and press
6. Highlight
C
will appear with up to three options (Port, Center and Starboard),
depending on your engine-tank configuration.
7. Select
P
ORT
Devices list.
8. Highlight UnCfg FFlow and press
appear: Press Enter to Configure Fuel Flow Sns.
9. Press
ENTER
Starboard and press
list where the fuel flows will be shown with their new configuration
names.
If desired configuration name available:
1. Press
MENU
press .
ENTER
2. Highlight
B
appear.
3. Select the fuel flow you want to reconfigure and press
Highlight
C
HANGE
appear with up to three options (Port, Center or Starboard), depending
on your engine-tank configuration.
4. Choose the desired configuration name and press
taken back to the Bus Devices list, where the fuel flow you reconfigured
will be displayed with its new configuration name.
Fuel Wrng (Fuel Warning)
Fuel Warning allows you to set a Low level or High level alarm for each
fuel flow on the network. A pop-up window will appear if your fuel rises
above or falls below a threshold of your choosing.
, use the
UP
and press
D
US EVICES
. You will be taken back to the Bus Devices list, where
and press
E
HANGE NGINE
and press
ENTER
, which will open the Select Engine menu. Choose
. You will be taken back to the Bus Devices
ENTER
, use the
UP
and press
D
US EVICES
and press
E
NGINE
and keys to select
DOWN
ENTER
ENTER
ENTER
. You will be taken back to the Bus
ENTER
and keys to select
DOWN
ENTER
. The Select Engine menu will
ENTER
41
S
YSTEM
. The Bus Devices list will
. Highlight
U
NSET
.
ENTER
. The Select Engine menu
. The following message will
S
YSTEM
. The Bus Devices list will
ENTER
and
S
ETUP
and
E
NGINE
and
S
ETUP
.
ENTER
. You will be