Table of Contents
Advertisement
NOTE:
You must use the gauge's Refill Tank command when filling your
fuel tank to keep the engine interface updated with correct
information on the amount of fuel in the tank.
Refill Tank
You must use the Refill Tank command every time you fill up and
every time you calibrate an engine interface to make sure the engine
interface reads the tank as full. For more information on the Refill
Tank function see page 26.
To calibrate a Suzuki Engine Interface:
Add the Fuel Manager page or any of the digital gauge pages to the
page screen rotation. Customize the page you added to show Fuel Used
data. To see instructions on how to Add Pages and Customize Pages,
refer to the Operation Section.
NOTE:
When following the steps below, run only ONE engine — the
engine connected to the engine interface.
1. Fill up the tank connected to the engine you want to calibrate.
2. Press
MENU
press
.
ENTER
3. Highlight
F
3. Select
R
EFILL
with up to three options: Port, Center and Starboard.
4. Select the tank you refilled and press
menu will appear with two options: Yes and No. Select
. The following message will appear: Press Enter after refilling
ENTER
the fuel tank.
5. Press
ENTER
engine connected to the engine interface Burn at least 5 gallons of fuel,
then fill up the tank again, noting how much fuel was added to the
tank. Check the Fuel Manager page for the fuel used figure calculated
by Suzuki Engine Interface.
6. Compare the amount of fuel added when you filled up the tank with
the Fuel Used figure shown on the LMF-400. If the difference between
these two numbers is greater than 3 percent, you need to calibrate the
interface.
NOTE:
If the difference between the LMF-400 fuel used figure and the
amount of fuel you actually added to the tank is less than 3
percent, do not calibrate the engine interface.
, use the
UP
and press
S
UEL
ETUP
and press
T
ANK
. Take your boat out, but run only ONE engine — the
and
keys to select
DOWN
.
ENTER
. The Select Tank menu will open
ENTER
59
S
YSTEM
. The ReCalibration
ENTER
and
S
ETUP
and press
N
O
Hide quick links:
Advertisement
Table of Contents
