Ep-15 Fluid Level Configuration - Lowrance LMF-400 Installation And Operation Instructions Manual

1. Press
MENU
press .
ENTER
2. Highlight
B
3. Select the desired fuel flow and press
Fuel Flow menu.
4. Highlight
F
appear with two options: Low Level and High Level. Typically, a Fuel
Level warning is used to alert you when your vessel is running low on
fuel, so highlight
window will appear, allowing you to set the level warning to the
desired percentage of tank capacity. It will be set to
turn off a level warning select Off.)
5. Use the
UP
percentage and press
list.
Reset Values:
By accessing the Reset Values command from the Fuel Flow menu, you
will be able to reset configuration and calibration settings for a
particular fuel flow.
1. Press
MENU
press .
ENTER
2. Highlight
B
to reset and press
3. Choose
R
ESET
following message will appear: Press Enter to Reset Device Values.
4. Press
ENTER
where the fuel flow will now be displayed as UnCfg F Flow.
NOTE:
By resetting values from the configuration menu, ONLY the device
selected from the Bus Devices list will be set back to its defaults.
When you Reset Values, the calibration and configuration settings
of the device are set back to factory defaults.

EP-15 Fluid Level Configuration

The LMF-400 will support up to three tanks for each Fluid Level type
which includes: Fuel, Fresh Water, Oil, Black Water, Waste Water
(Gray Water) and Live Well.
On the Bus Devices list, the fuel tanks will be displayed as Fuel Tank
(P) — Port Fuel Tank (C) — Center, and Fuel Tank (S) —Starboard. If
you chose a one-tank configuration in Boat Setup, the tank will be
listed as Fuel Tank.
, use the
UP
and press
D
US EVICES
and press
W
UEL RNG
L L
OW EVEL
and
DOWN
ENTER
, use the
UP
and press
D
US EVICES
.
ENTER
from the fuel flow menu and press
V
ALUES
and you will be taken back to the Bus Devices list,
and keys to select
DOWN
ENTER
ENTER
and press
ENTER
keys to set the desired fuel warning
. You will be taken back to the Bus Devices
and keys to select
DOWN
. Select the fuel flow you want
ENTER
42
S
to open the Bus Devices list.
, which will open the
ENTER
. The Select Level menu will
. The Set Level Percentage
O
FF
S
and
S
YSTEM ETUP
by default. (To
and
S
YSTEM ETUP
. The
ENTER