Table of Contents
Advertisement
2. Highlight
B
3. Select the desired engine interface and press
the Engine Interface menu.
4. Highlight
F
appear with two options: Low Level and High Level. Typically, a Fuel
Level warning is used to alert you when your vessel is running low on
fuel, so highlight
window will appear, allowing you to set the level warning to the
desired percentage of tank capacity (0-100%). It will be set to
default. (To turn off a level warning select Off.)
5. Use the
UP
percentage and press
list.
NOTE:
Make sure the fuel flow has been set as the Fuel Remaining Source,
otherwise, you will not be able to calibrate the fuel flow. See Fuel
Remaining Source instructions on page 28.
Reset Values:
By accessing the Reset Values command from the Engine Interface
menu, you will be able to reset configuration and calibration settings
for a particular engine interface.
1. Press
MENU
press
.
ENTER
2. Highlight
B
you want to reset and press
3. Choose
R
ESET
. The following message will appear: Press Enter to Reset Device
ENTER
Values.
4. Press
ENTER
where the engine interface now will be displayed as UnCfg Eng Intrfc.
NOTE:
By resetting values from the configuration menu, ONLY the device
selected from the Bus Devices list will be set back to its defaults.
When you Reset Values, the calibration and configuration settings
of the device are set back to factory defaults.
Calibrating EP Sensors
The factory calibration settings for the EP-10 Fuel Flow, EP-15 Fluid
Level and Suzuki Engine Interface should be adequate for the majority
of applications, so calibration will not be necessary in most cases.
The default calibration for the EP-15 Fluid Level is just as accurate as
and press
D
US
EVICES
and press
W
UEL
RNG
L
L
OW
EVEL
and
DOWN
ENTER
, use the
UP
and press
D
US
EVICES
from the Engine Interface menu and press
V
ALUES
and you will be taken back to the Bus Devices list,
ENTER
ENTER
and press
ENTER
keys to set the desired fuel warning
. You will be taken back to the Bus Devices
and
keys to select
DOWN
ENTER
.
ENTER
51
to open the Bus Devices list.
ENTER
. The Select Level menu will
. The Set Level Percentage
S
. Select the engine interface
. That will open
O
FF
and
S
YSTEM
ETUP
by
Hide quick links:
Advertisement
Table of Contents
