Change Units - Lowrance LMF-400 Installation And Operation Instructions Manual

Quad Analog. Pressure Range can make on-screen gauges easier to
read by allowing you to select a range that will better fit your vessel's
pressure range. If, for example, your vessel's water pressure range is 0-
30 PSI, the unnecessary figures (31-100 PSI) will only crowd the gauge
display, making it harder to read. Using the Pressure Range feature
allows you to eliminate unnecessary figures from the display, giving it
better resolution.
To set Pressure Range:
1. With the single analog, dual analog, quad analog, synchronization
page on the screen, press
and press
S S
YSTEM ETUP
2. Highlight
P
will open the Pressure range menu with the following options: Eng Wtr
Press (Engine Water Pressure), Eng Oil Press (Engine Oil Pressure),
Fuel Pressure, Eng Bst Press (Engine Boost Pressure) and Trns Oil
Press (Transmission Oil Pressure).
3. Select the desired pressure category and press
appear with these options: 0-15 PSI, 0-30 PSI, 0-60 PSI, 0-80 PSI, 0-
100 PSI.
4. Highlight the desired pressure range and press
taken back to the main display.

Change Units

The
C U
HANGE NITS
the following options: Speed/Distance, Temperature, Pressure, Depth,
GPS Coordinates and Volume.
System Setup menu (left) with Change Units highlighted. The Change
Units menu (right) with Speed/Distance selected.
To change Speed and Distance units:
Choosing Speed and Distance from the Change Units menu will allow
you to set the unit of measure for speed and distance to Statute,
Nautical or SI (Metric).
MENU
ENTER
(Pressure Ranges) and press
R
RESS ANGES
feature allows you to change the units of measure for
, use the
UP
.
24
and keys to select
DOWN
ENTER
. A menu will
ENTER
. You will be
ENTER
, which