Table of Contents
Advertisement
NOTE:
Ground Speed is the default speed source for Fuel Economy.
To change Economy Speed source:
1. Press
MENU
press
. Select
ENTER
2. Highlight
E
menu. The menu has three options: Water Speed (Paddlewheel), Pitot
Speed and Ground Speed (GPS).
3. Select the desired speed source and press
back to the main display.
Fuel Remaining Source
The Fuel Remaining source function allows you to select the device
used to measure the amount the fuel remaining in the tank.
NOTE:
If you plan to use a fluid level sensor for a fuel tank, you must
switch the fuel remaining source to Fuel Level. If you want to use
the EP-10 Fuel Flow, EP-50 Storage Device or the NMEA 2000
Suzuki Engine Interface to measure fuel remaining, select
Engine/FFlow from the Fuel Remaining Source menu.
To change Fuel Remaining Source:
1. Press
MENU
press
.
ENTER
2. Highlight
F
3. Select
F
UEL
4. Highlight the device you want to use to measure remaining fuel —
(Engine Fuel Flow) or
E
/FF
NG
LOW
and press
ENTER
Reset Trip Fuel
A few sensors, like the Suzuki Engine Interface, EP-10 Fuel Flow and
EP-50 Storage Device keep a running total of fuel used for a trip. By
using the Reset Trip command, you can reset to zero the running total
of fuel used on a trip.
To reset trip fuel:
1. Press
MENU
press
. Select
ENTER
2. Highlight
R
will appear with up to four options (Port, Center, Starboard and All
Engines), depending on the engine-tank configuration you selected
during Boat Setup. (If you have one tank, the Press Enter to reset Trip
Fuel message will appear.)
, use the
UP
F
S
UEL
ETUP
and press
S
CO SPEED
RC
, use the
UP
and press
S
UEL
ETUP
(Fuel Remaining Source) and press
R
S
EM
RC
. You will be taken back to the main display.
, use the
and
UP
F
S
UEL
ETUP
and press
T
F
ST
RIP
UEL
and
keys to select
DOWN
and press
ENTER
ENTER
and
keys to select
DOWN
.
ENTER
F
L
LUID
EV
keys to select
DOWN
and press
ENTER
ENTER
28
S
YSTEM
.
to open the Economy Speed
. You will be taken
ENTER
S
YSTEM
(Fluid Level Sensor) —
S
NSR
S
YSTEM
.
. The Select Engine menu
and
S
ETUP
and
S
ETUP
.
ENTER
and
S
ETUP
Hide quick links:
Advertisement
Table of Contents
