Advertisement
to place it on the transom where it will be in contact with the water at all
times, if possible. (See the above diagram.)
OPERATION
To use the LDT-3002, simply turn the power on. The water temperature
shows in degrees Fahrenheit (or Celcius if the green wire is grounded).
The LDT-3002 has up to three temperature displays. To switch between
these modes, simply press the mode key.
To change the temperature displays from Fahrenheit to Celsius, simply
press the °F / °C key. Press this key again to switch back to °F.
Water Temperature
The first temperature to appear after turning the LDT-3002 on is the water
temperature. This sensor is typically mounted on the transom and mea-
sures surface water temperature.
T2 Temperature
The second temperature to appear is T2. This sensor can be mounted in
a live well, on the hull to measure outside air temperature, or just about
any other location.
T3 Temperature
If you have the T3 temperature sensor installed, it appears after T2. This
sensor can also be mounted in a live well, on the hull to measure outside
air temperature, or just about any other location.
MODE
MODE
4
Advertisement
