Table of Contents
Advertisement
6. Select
O
UTSIDE
Devices list. The temp you just reconfigured (formerly water temp) will
now be displayed as Out: T.
7. To configure the unconfigured Temp (formerly Outside temp),
highlight
U
C
N
the Temp Selection menu, which will have three options: Water,
Outside and Inside. Highlight
taken back to the Bus Devices list, where the temp you just configured
will be displayed as WTR: T.
If desired configuration name available:
1. Press
MENU
press
.
ENTER
2. Highlight
to open the configuration options menu.
ENTER
3. Select
R
ECONFIGURE
menu, which will have three options: Water, Outside and Inside.
4. Highlight
O
Bus Devices list where the temp will now be shown as Out T.
EP-10 Fuel Flow Configuration
You can have up to three fuel flow sensors installed on your vessel, one
for each engine supported by the LMF-400. The number of fuel flows
listed on the Bus Devices list depends on the engine-tank configuration
you chose during Boat Setup. A three-engine configuration will display
fuel flows as Port Fuel Flow (Port FFlow), Center Fuel Flow (Cen
FFlow) and Starboard Fuel Flow (Stbd FFlow). When accessing a fuel
flow, its menu will appear with the following options: Change Engine
(for two or more engines only), Fuel Warning, Unset Engine, Reset
Values and Reset Calibration.
After a fuel flow has been added to the network, you are ready to
proceed with its configuration.
NOTE:
If, after configuring, unconfiguring or reconfiguring a fuel flow, it is
not shown on the Bus Devices list, you will have to refresh the list.
Press
MENU
and press
D
EVICES
configuration setting.
To configure an EP-10 Fuel Flow:
When you configure a fuel flow, you are linking the fuel flow's
location/engine on the boat to its matching configuration/device name
(Port, Center or Starboard) in the LMF-400.
and press
from the Bus Devices list and press
T
FG
EMP
, use the
UP
and press
B
D
US
EVICES
and press
and press
UTSIDE
, select
S
YSTEM
MENU
. You will be taken back to the Bus
ENTER
and press
W
ATER
and
keys to select
DOWN
ENTER
ENTER
. You will be taken back to the
ENTER
and press
S
ETUP
. The Fuel Flow will be listed with its new
39
ENTER
S
. Select
WTR: T
to open the Temp Selection
. Highlight
MENU
to open
ENTER
. You will be
and
S
YSTEM
ETUP
and press
B
US
Hide quick links:
Advertisement
Table of Contents
